Propellerhead Reason Specifications download pdf (Page 96)

REDRUM

The Effect Sends (S1 & S2)

On the back panel of Redrum you will note two audio connections labeled

“Send Out” 1 and 2. When you create a Redrum device, these will by default be

auto-routed to the first two “Chaining Aux” inputs on the Mixer device (provided

that these inputs aren’t already in use).

This feature allows you to add effects to independent drum sounds in the Re-

drum.

D Raising the S1 knob for a drum sound channel will send the sound

to the first send effect connected to the mixer.

Similarly, the S2 knob governs the send level to the second send effect in

the mixer.

D Note that there must be send effects connected to the AUX Sends

and Returns in the mixer for this to work.

D Also note that if Redrum is soloed in the Mixer the effect sends will

be muted.

D Another way to add independent effects to drum sounds is to use

the independent drum outputs.

See page 97.

Pan

Sets the Pan (stereo position) for the channel.

D If the LED above the Pan control is lit, the drum sound uses a stereo

sample.

In that case, the Pan control serves as a stereo balance control.

Level and Velocity

The Level knob sets the volume for the channel. However, the volume can also

be affected by velocity (as set with the Dynamic value, or as played via MIDI).

How much the volume should be affected by velocity is set with the “Vel” knob.

D If the Vel knob is set to a positive value, the volume will become

louder with increasing velocity values.

The higher the Vel value, the larger the difference in volume between low

and high velocity values.

D A negative value inverts this relationship, so that the volume de-

creases with higher velocity values.

D If the Vel knob is set to zero (middle position), the sound will play at

a constant volume, regardless of the velocity.

When Vel is set to zero, the LED above the knob goes dark.

Length and the Decay/Gate switch

The Length knob determines the length of the drum sound, but the result de-

pends on the setting of the Decay/Gate switch:

D In Decay mode (switch down), the sound will decay (gradually fade

out) after being triggered. The decay time is determined by the

Length setting.

In this mode, it doesn’t matter for how long a drum note is held (if played

back from the main sequencer or via MIDI) - the sound will play the same

length for short notes as for long notes. This is the traditional “drum ma-

chine” mode.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 297 298

Comments to this Manuals

Vikitvv 04 Jan 2024 | 13:04:50

urenrjrjkvnm

Evabhf 07 Jan 2024 | 16:01:45

Med

Viktoridbv 14 Jan 2024 | 00:33:23

Cinema

Propellerhead Reason Specifications Page 96

Comments to this Manuals

Related products and manuals for Software Propellerhead Reason