Propellerhead Reason Specifications download pdf (Page 239)

THE EFFECT DEVICES

237

The EQ section

The equalizer in RV7000 affects the wet reverb sound only and is used for shap-

ing the character of the reverb. There are two EQ bands, one for low frequencies

(shelving) and one full-range parametric EQ.

D To activate the EQ, click the EQ Enable button on the main panel so

that the indicator lights up.

D To make EQ settings, select “EQ” with the Edit Mode button to the

left in the remote programmer panel.

D In this mode, the remote programmer display shows a frequency

curve, indicating the settings you make with the EQ parameters.

The parameters are:

D Remember that you have a third EQ band at your disposal - the HI

EQ parameter on the main panel.

The reason why this is on the main panel and not in the EQ section is simply

that it’s a setting you may want to adjust often, without having to open the re-

mote programmer panel.

The Gate section

The Gate section allows you to create gated reverb effects with a lot of options

and possibilities. You can either trigger the gate from the source audio signal or

via MIDI or CV.

When triggering the gate from the source audio signal, it works like this:

• The gate “listens” to the source (dry) signal and opens whenever the signal

reaches a certain threshold level.

• The reverb sound is sent through the gate - when the gate is closed you

won’t hear the reverb.

• When the source signal level drops below the threshold level, the gate

closes after a time that depends on the Hold parameter and the level of the

source signal (see the parameter table).

D If you need the gate to be open for an exact duration (time), you

should trigger it via MIDI or CV.

In audio trigger mode, the actual gate time will vary depending on the source

signal.

When triggering the gate via MIDI or CV, it works like this:

• The reverb sound is sent through the gate - when the gate is closed you

won’t hear the reverb.

• Whenever the gate receives any MIDI note (sent to the RV7000) or a gate

signal (connected to the Gate Trig CV input on the back of the RV7000), the

gate opens for the duration of the note or gate signal.

Note:

D To activate the Gate, click the Gate Enable button on the main

panel so that the indicator lights up.

D To make Gate settings, select “Gate” with the Edit Mode button to

the left in the remote programmer panel.

D In this mode, the remote programmer display shows two meters -

one showing the signal level (with an indication of the threshold

level) and one showing the status of the gate.

This is useful for checking what happens, how the gate triggers, etc.

| Parameter | Description

Low Gain The amount of cut or boost of the low-shelving filter.

Low Freq The frequency below which the Low Gain cut or boost is ap-

plied.

Param Gain The amount of cut or boost for the parametric EQ.

Param Freq The center frequency of the parametric EQ, e.g. at which fre-

quency the level should be decreased or increased.

Param Q This governs the width of the affected area around the set

center frequency. The higher the value, the narrower the af-

fected frequency range.

1 2 ... 234 235 236 237 238 239 240 241 242 243 244 ... 297 298

Comments to this Manuals

Vikitvv 04 Jan 2024 | 13:04:50

urenrjrjkvnm

Evabhf 07 Jan 2024 | 16:01:45

Med

Viktoridbv 14 Jan 2024 | 00:33:23

Cinema

Propellerhead Reason Specifications Page 239

Comments to this Manuals

Related products and manuals for Software Propellerhead Reason